A frayed or snapped lift cable throws the whole door off balance, and a door hanging crooked on one cable is a genuine safety hazard. We replace cables and inspect the drums they wind onto.
When one lift cable fails, the other has seen the same wear cycle. We replace both to prevent a repeat call.
A cable can slip its groove repeatedly if the drum itself is damaged, which we check before calling the job done.
Lift cables connect directly to spring-loaded drums, so replacement requires the same careful tension handling as spring work.
We carry the common cable lengths and gauges for most residential door sizes.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
A snapped cable leaves the door hanging unevenly on the remaining side, an unsafe condition we treat as priority.
Fraying cable strands are a warning sign of imminent failure. We replace before it snaps and drops the door unexpectedly.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
Worn or cracked cable drums get replaced alongside the cable itself, since a damaged drum will fray the next cable too.
A door hanging crooked usually means one cable or spring has failed while the other holds. We correct both the immediate hazard and the root cause.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Technicians carry standard cable gauges and lengths for most residential doors.
We check both cables and the drums together, then quote a flat price covering the full fix.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Door was hanging at an angle after a cable snapped. They replaced both cables and it's perfectly level now.”
“Caught the fraying cable during a routine call before it actually snapped. Appreciated the heads-up.”
“Door was jamming mid-cycle for weeks. Cable and drum issue, fixed in one visit.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
We recommend replacing both since they wear on the same cycle, and we'll explain the reasoning before you decide.
Yes, a door hanging on a single cable or spring can drop unexpectedly and should not be operated until repaired.
Usually a bent or worn drum groove, sometimes combined with a slightly loose cable tension setting.
Pricing depends on cable length, gauge, and whether the drums also need replacing, confirmed as a flat number before work starts.
Standard cable and drum stock means same-visit repair is the norm, not the exception.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Mountain Brook to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Mountain Brook, AL